Initio INI-9100UW - Manual (Page 82)

9-2
IBM OS/2 Driver Installation
Overview
The Initio INI-9100U/9100UW OS/2 driver will support OS/2, 3.0 & 4.0. The
device driver for OS/2 is copied from the INITIO INI-9100U/9100UW
DRIVER DISK 1 to your hard drive where it is initialized during boot-up.
The installation of Initio device drivers to support OS/2 include the following
software files and may be found on the INITIO INI-9100U/9100UW DRIVER
INSTALLATION DISK 1:
\OS2\INI910U. ADD INI-9100U/9100UW SCSI Host Adapter OS/2
driver.
\OS2\INI910U.DDP Script file for installing INI910U.ADD
Reference Documentation:
•
OS/2 installation and user’s guide
•
The systems setup and installation guide
•
The documentation for system peripherals
•
Initio documentation for the SCSI host adapter
Installation
The INI-9100U/9100UW driver developed for OS/2 will be installed on the
disk drive used for system initialization. The driver is loaded during the system
boot routine and will remain resident on the drive. Installation of the drivers
can be accomplished by following one of the procedures listed:
•
New OS/2 Installation
•
Adding INI-9100U/9100UW host adapter to existing OS/2
The steps used to install the Initio drivers have different system requirements
that may affect basic operation if not installed properly. It is strongly suggested