Initio INI-9100UW - Manual (Page 26)

2-6
•
Install the internal cable by matching the cable ‘striped side’ with
the card connector ‘
∇
‘, J1 pin 1 on the INI-9100U/9100UW.
Complete the SCSI bus by connecting the cable to the other SCSI
peripherals in your system. Please refer to the specific peripheral
manufacturers users manuals for proper SCSI cable installation.
•
Close the cover on host computer. This completes the hardware
installation of the INI-9100U/9100UW.
Cable termination
•
Host adapter auto-termination is software controlled by the
SmartSCSI

Setup Utility. Auto-termination is enabled by
default during power-up. Recall that first and last physical SCSI
device on the SCSI bus must be terminated.
•
Refer to the specific peripheral manufacturers users manual for
proper SCSI cable termination.
Configuring the host adapter
Host adapter configuration is performed automatically by the host adapter
BIOS during power-up. The factory settings are designed for best
operation. However, the host adapter can be configured to meet your
special operating environment, using the SmartSCSI

Setup Utility
described below.
The INI 9100U/9100UW host adapter includes an on-board configuration
utility called the SmartSCSI

Setup Utility. The utility is accessible
during the system boot routine, after the Initio banner is displayed, by
pressing <Ctrl>+<I> on the host system keyboard. The SmartSCSI

Setup
Utility is resident in the host adapter’s Read Only Memory (ROM). The
purpose of the SmartSCSI

Setup Utility is to customize SCSI/BIOS-
related parameters and perform low level SCSI disk formatting when
required. Once the configuration is established the information is saved in
on-board non-volatile memory which can be modified when necessary in