Initio INI-9100UW - Manual (Page 72)

8-2
Novell NetWare Driver Installation
Overview
The Initio INI-9100U/9100UW will support Novell NetWare 386 V4.XX or
V3.1X with the addition of a software driver. The installation procedure
described here requires some experience in Novell system setup and
administration. The device driver is transferred from the INITIO INI-
9100U/9100UW DRIVER DISK 1 to the hard drive where it is automatically
initialized during the system boot routine. The device drivers listed can support
NetWare versions described after the Initio file name:
\NETWARE\V31X\INI910U.DSK Initio Novell adapter driver for
V3.1X
\NETWARE\V31X\ASPITRAN.DSK ASPI transport layer driver for
V3.1X
\NETWARE\V4X\INI910U.DSK Initio Novell adapter driver for
V4.X or later
\NETWARE\V4X\INI910U.DDI Device driver installation file
\NETWARE\V4X\ASPITRAN.DSK ASPI transport layer driver for
V4.X or later
\NETWARE\HAM\INI9100.HAM HAM device driver
\NETWARE\HAM\INI9100.DDI HAM device driver installation file
Reference Documentation:
•
Novell NetWare installation and user’s guide
•
The systems setup and installation guide
•
The documentation for system peripherals
•
Initio documentation for the SCSI host adapter
System Requirement:
•
Installed primary floppy diskette drive.
•
Installed MS-DOS/ASPI driver on resident hard drive.
•
Installed and configured CD-ROM drive (driver provided by Corel).