Initio INI-9100UW - Manual (Page 63)

7-3
The procedures described to make changes to the system have distinct
differences. It is strongly suggested that the selected procedure be read and
understood before proceeding with the system configuration changes. Please
read the instructions carefully.
New Windows-NT installation
These instructions will guide you through the installation of the Initio host
adapter driver while installing Windows-NT 4.0. Windows-NT will be installed
from either floppy diskettes or CD-ROM. The Windows-NT driver will be
found on the INITIO INI-9100U/9100UW DRIVER DISK 1. It is important
that the hardware has been installed successfully before proceeding further.
1. If you are installing Windows-NT from floppy diskettes, locate the
Windows-NT Disk 1 for Floppy Installation. Make a backup copy of
this diskette before installation.
2. If you are installing Windows-NT from a CD-ROM drive, locate the
Windows-NT Setup Disk for CD-ROM Installation. Make a backup
copy of this diskette before installation.
3. Insert the backup Windows-NT Setup disk into drive A: and turn on
your computer.
4. Follow the instructions on the screen. The following
message will be displayed on your screen (see figure 7-1):