Initio INI-9100UW - Manual (Page 66)

7-6
figure 7-4 Select Initio driver
6. The Initio host adapter driver is now installed
7. The on-screen instructions will continue for a complete installation of
Windows-NT. Refer to your Windows-NT users manual for
completion of the operating system installation procedure.
Adding or updating the Initio driver to an existing Windows-
NT system:
For computer systems using other SCSI host adapters or an IDE drive to
provide the system boot routine, these instructions will guide you through the
INI-9100U/9100UW host adapter driver installation. The Windows-NT driver
will be found on the INITIO INI-9100U/9100UW DRIVER DISK 1. It is
important that the SCSI bus hardware and Windows-NT are installed and
configured before proceeding further.
1. Once a Windows NT session is established, use your installed mouse or the
appropriate key strokes to select MY COMPUTER from the Main
Desktop. Execute the following steps:
•
Select CONTROL PANEL from within the MY COMPUTER group.
•
Select SCSI ADAPTERS from within the CONTROL PANEL group.