Initio INI-9100UW - Manual (Page 48)

5-3
3. At the MS-DOS prompt, change to your active floppy drive (e.g., type
A: <ENTER>).
4. Type DOSSETUP <ENTER>
•
A series of screens will guide you through the installation of the
ASPI device drivers.
5. The first screen sets the installation drive and directory that the ASPI
driver will be installed on. Follow the on-screen directions and/or
options to continue the installation.
6. To activate the device driver, reboot the system by pressing <CTRL>
+ <ALT> + <DEL>.
If a CD-ROM, tape drive, scanner, or optical drive is installed on your system,
a third party device driver is needed. A driver may be provided by the
manufacturer and is used in addition to the Initio ASPI driver to provide proper
support for that device. Please refer to your peripheral device manufacturer
documentation for additional information.
Installing the Initio ASPI driver to an existing Windows 3.1x
system
The ASPI for Windows 3.1x driver is found on the INITIO INI-
9100U/9100UW DRIVER DISK 1. It is important that the SCSI bus hardware,
and operating system are installed correctly before proceeding further. If you
need help installing Windows 3.1x, please refer to the Microsoft Windows
manual before proceeding.
1. Turn on host system and boot into MS-DOS and Windows
3.1x operating system.
2. Insert the INITIO INI-9100U/9100UW DRIVER DISK 1 into your
floppy drive.
3. Use your installed mouse or the appropriate key strokes to select
RUN… from the Windows PROGRAM MANAGER. Execute the
following steps:
•
Type A:\SETUP <ENTER>. A series of screens will guide you
through the installation of the ASPI for Windows device drivers.