Initio INI-9100UW - Manual (Page 57)

6-6
Adding the Initio Driver to an existing Windows 95 system
These instructions will guide you through the installation of the Initio host
adapter to an existing Windows 95 system. Windows 95 will automatically
detect the presence of new hardware in Plug and Play compliant systems. It is
important that the Initio INI-9100U/9100UW hardware has been properly
installed before proceeding further.
1. Microsoft Windows 95 will detect the presence of new hardware upon
boot-up and will display a dialog window titled NEW HARDWARE
FOUND and PCI SCSI BUS CONTROLLERS will be highlighted.
•
Select: DRIVER FROM DISK PROVIDED BY HARDWARE
MANUFACTURER, then “OK”.
•
Select SCSI CONTROLLER from the list of available devices, then
select “HAVE DISK...”
2. In the INSTALL FROM DISK window that is displayed, enter the Initio
Driver path name:
•
Insert INITIO INI-9100U/9100UW DRIVER DISK 1 into drive A:
•
Type: A:\WIN95, select “OK”
3. Select INITIO INI-9100U/9100UW Host Adapter, select “OK”, then
“OK” again to install the INI910U.MPD driver onto your hard disk drive.