InFocus IN5122 - Manual (Page 21)

19
If you want to change the Network
configuration already added, click [Change].
A dialog for changing the Network
configuration as shown on the right will be
displayed. Enter the IP address and subnet
mask, and then click [OK]. The procedure to
connect to the projector will begin.
Go to 1.8 Confirming the connection to
your destination
. (&30)
If you click [Cancel], you will return to the
dialog for adding a Network configuration.
If the entered IP address and projector's IP
address are the same, a warning dialog shown
to the right will be displayed.
Click [OK], and then enter a different IP
address from the projector's one in the dialog
to change the Network configuration.
If the connection is not available with the
entered Network configuration, a warning
dialog shown to the right will be displayed.
Click [OK] to return to the dialog for changing
the Network configuration, and then enter
appropriate configuration.
If you put a checkmark in the box “Not displaying confirmation dialog for adding
Network settings”, the projector memorizes the current configuration and this
dialog will not be displayed again. To display this dialog again, click the Option
icon in the “LiveViewer” main menu and remove the checkmark in the box “Not
displaying confirmation dialog for adding Network settings”.
1. Connection to the network
1.5 Selecting the network connection method (continued)
• If a Network configuration to connect to the projector has been added
on the computer, the added Network configuration will be erased once the
application software is closed.
NOTE