InFocus IN5122 - Manual (Page 32)

30
1.8 Confirming the connection to your destination
When the network connection is established,
the “Connection to Projector successful” dialog
will be displayed.
Make sure the correct projector you want to
send your image to is selected, by checking the
projector name and IP address shown in the
screen.
1.8.1 Connection and transmission
• To send images to the projector, click [Yes]. The transmission will start.
To display the transmitted images, select the LAN port as input source on the
projector.
• Click [No] to stop image transmission to the projector. The “LiveViewer”
main menu will be displayed in stand-by mode. (Standby mode is the state
where there is no image transmission, although the network connection is
established.)
The transmission can be started, if you click or button on the “LiveViewer”
main menu.
[Troubleshooting]
The projector you want to send your images
to is being used by another computer in the
Presenter mode.
Click [OK], and the “LiveViewer” main menu
will display in stand-by mode. You can
attempt to resend your images, after the
Presenter mode is off.
n This projector is currently in use (Presenting) by another user.
If you wish to use the current connection setting as profile for My Connection,
check the box [Register this setting to My Connection].
1. Connection to the network