InFocus IN5122 - Manual (Page 72)

70
4. My Image Feature
4. My Image Feature (Continued)
Configure the following items from a web browser when MY IMAGE feature is
used.
Example
: If the IP address of the projector is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the address bar of the web browser.
2) Enter your user name and password,
and then click [OK].
3) Click [Port Settings] on the main
menu.
4) Click [Enable] to open the My Image
Port (Port: 9716)
. Click [Enable]
for [Authentication] setting when
authentication is required, otherwise
clear the checkbox.
5) Click [Apply] button to save the
settings.
When the authentication setting is enabled, the following settings are required.
6) Click [Security Settings] on the main menu.
7) Select [Network Control] and enter the desired authentication password.
8) Click [Apply] button to save the settings.
• The Authentication Password will be the same for Network Control
Port1 (Port: 23)
, Network Control Port2 (Port: 9715), PJLink™ Port (Port:
4352)
, My Image Port (Port: 9716) and Messenger Port (Port: 9719).
• The new configuration settings are activated after the network connection has
been restarted. When the configuration settings are changed, you must restart
the network connection. You can restart the network connection by clicking
[Network Restart]
on the Advanced Menu>Network submenu.
NOTE