InFocus IN5122 - Manual (Page 28)

26
Wireless LAN
SSID: WirelessAccessPoint (example)
Encryption: WEP64bit (example)
Encryption key *2: ********** (example)
Mode: INFRASTRUCTURE
2) Click [Next].
3) Enter the following information that is set in
the projector. *3
IP address : 192.168.1.10 (example)
Subnet mask: 255.255.255.0 (example)
4) Click [Connect].
5) The wireless connection will be established.
Go to 1.8 Confirming the connection to your destination. (&30)
1) The access point settings. *1
Enter the following information.
*1
Contact the network administrator to find out the access point settings.
*2
If you are using encryption, you need to set it. Contact the network
administrator to check the encryption key that is set in the projector.
The encryption key is always shown as “**********”.
*3
To find out the projector's network settings, refer to the NOTE. (&22)
1.7 Configuring the network settings manually (continued)
1. Connection to the network