InFocus IN5122 - Manual (Page 23)

21
After entering the Passcode (&17), you must enter the network configuration
settings manually if you are using a Subnet mask other than Class A, B or C. (&15)
If you are using a wired LAN, go to (&22).
(3) Configuring manually
Wireless LAN
The projector must be connected to an access point by a LAN cable.
1. Connection to the network
1.5 Selecting the network connection method (continued)
SSID : WirelessAccessPoint (example)
Encryption: WEP64bit (example)
Encryption key *2: ********** (example)
2) The setting on the projector. *3
Enter the following information.
1) The access point settings. *1
Enter the following information.
3) Click [Connect].
4) The wireless connection will be established.
Go to 1.8 Confirming the connection to your destination. (&30)
*1
Contact the network administrator to find out the access point settings.
*2
If you use an encryption, you need to set it. Contact the network administrator
to check the encryption key that is set in the projector.
The encryption key is always shown as “**********”.
*3
To find the projector's network settings, refer to the NOTE. (&22)
*4
If you use Subnet mask except Class A/B/C, please set it.
Subnet mask *4: 255.255.255.128
(example)