InFocus IN5122 - Manual (Page 30)

28
1.7 Configuring the network settings manually (continued)
1. Connection to the network
This dialog will be displayed when you need
to add the Network configuration to your
computer in order to connect to the projector.
Confirm the Network configuration settings
displayed with your Network Adminstrator,
and then click [Yes].
n If you need to configure your computer to connect to the projector:
Clicking [NO] will cause the “LiveViewer” main menu to be displayed even
though the network connection has not been established. Click on the main
menu and go back to 1.5 Selecting the network connection method. (&14)
If you want to change the Network
configuration already added, click [Change].
A dialog for changing the Network
configuration as shown to the right will be
displayed. Enter the IP address and subnet
mask, and then click [OK]. The procedure to
connect to the projector will begin.
Go to 1.8 Confirming the connection to
your destination
. (&30)
If you click [Cancel], you will return to the
dialog for adding a Network configuration.
If you put a checkmark in the box “Not displaying confirmation dialog for adding
Network settings”, the projector memorizes the current configuration and will not
display the above dialog again. To display this dialog again, click the Option
icon in the “LiveViewer” main menu and remove the checkmark in the box “Not
displaying confirmation dialog for adding Network settings”.