Button press - event notification, Button event sent to host rs-232, Scan engine commands – Symbol Technologies MK1000 User Manual
Page 116: Changing the scanning mode (scan pattern), Button press - event notification -14, Button event sent to host rs-232 -14, Scan engine commands -14, Changing the scanning mode (scan pattern) -14
5-14
MK1000 MicroKiosk Product Reference Guide
Button Press - Event Notification
When one of the MK1000 function buttons is depressed, a string is sent to the host where
<Keypad digit, 1 through 4> is the number of the button pressed. For example, "BTN4" is
sent to the host when the right most button, ‘4’, is pressed. This event notification must be
surrounded by the normal framing characters used by the PCK emulation firmware (which
are dependent on communications type described in
Button Event Sent to Host RS-232
Scan Engine Commands
Changing the Scanning Mode (Scan Pattern)
To change the scanning mode, the host sends the MK1000 the following command
sequence:
<Esc> [ <scanning mode number> s
The following is a list of scanning mode numbers:
To change the scanning mode to Smart Raster, the scanning mode number 1 would be
used.
MK1000
Host
<STX>BTN4<ETX><LRC>
<ACK>
<EOT>
Number
Scan Mode
1
Smart Raster
2
Always Raster
6
Cyclone Omnidirectional
(1D scanning only)
7
Semi-Omni Pattern