Wired ethernet setup, Wired ethernet: power via ac outlet, Wired ethernet setup -2 – Symbol Technologies MK1000 User Manual

Page 32: Wired ethernet: power via ac outlet -2

Advertising
background image

2-2

MK1000 MicroKiosk Product Reference Guide

Wired Ethernet Setup

The MK1000 can communicate with a host via a wired Ethernet connection (10Base-T
cable).

When communicating in this manner the MK1000 can be powered either using the
MK1000’s power supply connected to an AC outlet, or by receiving Power-over-Ethernet
through the Ethernet cable.

Wired Ethernet: Power via AC Outlet

With this installation option, the MK1000 communicates to the host via a 10Base-T Ethernet
cable and receives power via a power supply plugged into an AC outlet.

To install the MK1000, follow the instructions below.

1.

Provide power to the MK1000 using its power supply.

•

Insert the round barrel connector at the end of the power supply cable into the
MK1000’s Power port. (See

Figure 1-1 on page 1-3

for port locations.)

•

Plug the power supply into a wall outlet.

2.

Attach the Ethernet cable.

•

Connect the Ethernet cable to the LAN port on the MK1000. (See

Figure 1-1 on

page 1-3

for port locations.) Ensure the Ethernet cable is terminated according

to the

Ethernet Pin-Outs: Obtaining Power via AC Power Supply

described in

Table 2-1

and

Table 2-2

.

•

Plug the other end of the Ethernet cable into the host system’s LAN port.

3.

To mount the MK1000, see Mounting the MK1000 on page 2-11.

After completing the mechanical installation of the MK1000, refer to

Chapter 3, Setup and

Installation: Communication

to establish communication with the host.

Advertising