Symbol Technologies MK1000 - Manual (Page 195)

F-13
Troubleshooting
(continued)
MK1000 will not communicate
over a wireless-Ethernet
connection.
3. Confirm the Wireless (RF)
Ethernet Setup is ENABLED.
- On the Radio Configuration screen
(3rd line), Enabled must = Yes.
- If Enabled = No, with the cursor
on Enabled, press the ‘4’ button.
Enabled should now = Yes. See
Troubleshooting Note 1.
- Press ‘1’ (Network Configuration
screen will re-appear)
4. Confirm the Wired Ethernet
Setup is DISABLED.
- Scroll the cursor up to Ethernet by
pressing ‘2’
- With the cursor on Ethernet, press
‘4’ (Ethernet Configuration screen
appears).
- On the Ethernet Configuration
screen (3rd line), Enabled must =
No.
- If Enabled = Yes, with the cursor
on Enabled, press the ‘4’ button.
Enabled should now = No. See
Troubleshooting Note 1.
- Press ‘1’ (Network Configuration
screen re-appears).
- Press ‘1’ (MK1000 Configuration
screen re-appears).
(continued)
Table F-1. Troubleshooting (Continued)
Problem Possible Causes Possible Solutions