Wireless ethernet: power via power-over-ethernet – Symbol Technologies MK1000 User Manual

Page 35

Advertising
background image

2-5

Setup and Installation: Mechanical

Wireless Ethernet: Power via Power-over-Ethernet

With this installation option, the MK1000 communicates to the host via a wireless (RF)
connection and receives power via an Ethernet cable.

Note: This Ethernet cable does NOT provide data to the MK1000.

To install the MK1000, follow the instructions below.

1.

Attach the Ethernet cable to provide power to the MK1000.

•

Connect the Ethernet cable to the LAN port on the MK1000. (See

Figure 1-1 on

page 1-3

for port locations.) Ensure the Ethernet cable is terminated according

to the

Ethernet Pin-Outs: Obtaining Power via Power-over-Ethernet

described

in

Table 2-3

and

Table 2-4

.

•

Plug the other end of the Ethernet cable in the hub.

2.

Connect a patch cable from the Bias-T (Power-over-Ethernet) module to your host
system’s LAN port.

3.

To mount the MK1000, see Mounting the MK1000 on page 2-11.

After completing the mechanical installation of the MK1000, refer to

Chapter 3, Setup and

Installation: Communication

to establish communication with the host.

Advertising