Port-based virtual lans (static vlans) – SMC Networks SMC TigerStack II SMC6624M User Manual
Page 218
9-48
Configuring Advanced Features
Port-Based Virtual LANs (Static VLANs)
Co
nf
ig
u
ri
ng Adva
nce
d
Feat
u
res
Port-Based Virtual LANs (Static VLANs)
VLAN Features
A VLAN is a group of ports designated by the switch as belonging to the same
broadcast domain. (That is, all ports carrying traffic for a particular subnet
address would normally belong to the same VLAN.)
N o t e
This section describes static VLANs, which are VLANs you manually config-
ure with a name, VLAN ID (VID), and port assignments. (For information on
dynamic
VLANs, see “GVRP” on page 9-74.)
Using a VLAN, you can group users by logical function instead of physical
location. This helps to control bandwidth usage by allowing you to group high-
bandwidth users on low-traffic segments and to organize users from different
LAN segments according to their need for common resources.
By default, the SMC6624M switch is 802.1Q VLAN enabled and allows up to
30 port-based VLANs (default: 8). For information on GVRP, see “GVRP” on
page 9-74. (The 802.1Q compatibility enables you to assign each switch port
to multiple VLANs, if needed, and the port-based nature of the configuration
allows interoperation with older switches that require a separate port for each
VLAN.)
General Use and Operation.
Port-based VLANs are typically used to
enable broadcast traffic reduction and to increase security. A group of net-
work users assigned to a VLAN form a broadcast domain that is separate from
other VLANs that may be configured on a switch. Packets are forwarded only
between ports that are designated for the same VLAN. Thus, all ports carrying
traffic for a particular subnet address should be configured to the same VLAN.
Cross-domain broadcast traffic in the switch is eliminated and bandwidth is
Feature
Default
Menu
CLI
Web
view existing VLANs
n/a
configuring static
VLANs
default VLAN with
VID = 1
configuring dynamic
VLANs
disabled