SMC Networks SMC TigerStack II SMC6624M User Manual
Page 334
A-10
Transferring an Operating System or Startup Configuration File
Transferring Switch Configurations
Tra
n
sf
er
ri
ng an
Op
era
ti
n
g
S
yst
em
or St
a
rt
u
p
TFTP: Copying a Configuration to a Remote Host.
Syntax:
copy startup-config tftp <ip-addr> <remote-file>
This command copies the switch’s startup configuration (startup-config file)
to a remote TFTP host.
For example, to upload the current startup configuration to a file named
sw2512 in the configs directory on drive “d” in a remote host having an IP
address of 13.28.227.105:
SMC TigerSwitch 10/100# copy startup-config tftp
13.28.227.105 d:\configs\sw2512
Xmodem: Copying a Configuration from the Switch to a Serially
Connected PC or Unix Workstation.
To use this method, the switch must
be connected via the serial port to a PC or Unix workstation to which you
want to copy the configuration file. You will need to select a filename, and to
know the drive and directory location where you want to store the configura-
tion file.
Syntax:
copy startup-config xmodem <pc | unix>
For example, to copy a configuration file to a PC serially connected to the
switch:
1.
Execute the following command:
2.
After you see the above prompt, press [Enter].
3.
Execute the terminal emulator commands to begin the file transfer.