SMC Networks SMC TigerStack II SMC6624M - Manual (Page 78)

5-10
Configuring IP Addressing, Interface Access, and System Information
IP Configuration
C
onf
ig
uri
n
g
I
P
Ad
dre
ssi
ng,
In
te
rf
a
ce Acc
e
ss,
an
d
Table 5-1. Features Available With and Without IP Addressing on the Switch
DHCP/Bootp Operation
Overview. DHCP/Bootp is used to provide configuration data from a DHCP
or Bootp server to the switch. This data can be the IP address, subnet mask,
default gateway, Timep Server address, and TFTP server address. If a TFTP
server address is provided, this allows the switch to TFTP a previously saved
configuratin file from the TFTP server to the switch. With either DHCP or
Bootp, the servers must be configured prior to the switch being connected to
the network.
N o t e The SMC6624M switch is compatible with both DHCP and Bootp servers.
The DHCP/Bootp Process. Whenever the IP Config parameter in the switch
or in an individual VLAN in the switch is configured to DHCP/Bootp (the
default), or when the switch is rebooted with this configuration:
Features Available Without an IP Address Additional Proactive Networking Features Available
with an IP Address and Subnet Mask
• Direct-connect access to the CLI and the menu
interface.
• Stacking Candidate or Stack Member
• DHCP or Bootp support for automatic IP address
configuration, and DHCP support for automatic Timep
server IP address configuration
• Spanning Tree Protocol
• Port settings and port trunking
• Console-based status and counters information for
monitoring switch operation and diagnosing problems
through the CLI or menu interface.
• VLANs
• GVRP
• Serial downloads of operating system (OS) updates
and configuration files (Xmodem)
• Link test
• Port monitoring
• Security
• Web browser interface access, with configuration,
security, and diagnostic tools, plus the Alert Log for
discovering problems detected in the switch along
with suggested solutions
• SNMP network management access such as
EliteView network configuration, monitoring, problem-
finding and reporting, analysis, and recommendations
for changes to increase control and uptime
• Stacking Commander*
• Telnet access to the CLI or the menu interface
• IGMP
• Timep server configuration
• TFTP download of configurations and OS updates
• Ping test
*Although a Commander can operate without an IP address, doing so makes it unavailable for in-band access in an
IP network.