SMC Networks SMC TigerStack II SMC6624M - Manual (Page 86)

5-18
Configuring IP Addressing, Interface Access, and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
C
onf
ig
uri
n
g
I
P
Ad
dre
ssi
ng,
In
te
rf
a
ce Acc
e
ss,
an
d
Reconfigure Web Browser Access. In the default configuration, web
browser access is enabled.
Syntax: [no] web-management
To disable web browser access:
SMC TigerSwitch 10/100(config)# no web-management
To re-enable web browser access:
SMC TigerSwitch 10/100(config)# web-management
Reconfigure the Console/Serial Link Settings. You can reconfigure one
or more console parameters with one console command.
Syntax: console
[terminal <vt100 | ansi>]
[screen-refresh <1 | 3 | 5 | 10 | 20 | 30 | 45 | 60>]
[baud <speed-sense | 1200 | 2400 | 4800 | 9600 | 19200 |38400 | 57600>]
[flow-control <xon/xoff | none>]
[inactivity-timer <0 1 5 10 15 20 30 60 120>]
[events <none | all | non-info | critical | debug]
N o t e If you change the Baud Rate or Flow Control settings for the switch, you
should make the corresponding changes in your console access device. Oth-
erwise, you may lose connectivity between the switch and your terminal
emulator due to differences between the terminal and switch settings for these
two parameters.
All console parameter changes except events require that you save the config-
uration with write memory and then execute boot before the new console
configuration will take effect.
For example, to use one command to configure the switch with the following:
■ VT100 operation
■ 19,200 baud
■ No flow control
■ 10-minute inactivity time
■ Critical log events
you would use the following command sequence: