Operating elements – KTM 450 EXC-R EU User Manual
Page 19
OPERATING ELEMENTS
17
Display mode SPEED
b/bCLK (time)
400319-01
ದ
Press the button
b
briefly and repeatedly until CLK appears at the bottom right of
the display.
The time is displayed in CLK display mode.
Press the button
b"+". no function
Press the button
b"ತ". no function
Press the button
b
for 3 - 5 seconds.
The display changes to the Setup menu of the clock.
Press the button
b
briefly.
next display mode
Display mode SPEED/LAP (lap time)
400320-01
ದ
Press the button
b
briefly and repeatedly until LAP appears at the bottom right of
the display.
In the LAP display mode, up to 10 lap times can be timed with the stop watch.
Info
If the lap time continues after you press the button
b"ತ", 9 memory locations are
already occupied.
Lap 10 must be timed with the button
b"+".
Press the button
b"+". Starts or stops the clock.
Press the button
b"ತ". Stops the current lap time and saves it, and the stop watch
starts the next lap.
Press the button
b
for 3 - 5 seconds.
The stop watch and the lap time are reset.
Press the button
b
briefly.
Next display mode
Display mode SPEED/ODO (odometer)
400317-01
ದ
Press the button
b
briefly and repeatedly until ODO appears at the bottom right of
the display.
In ODO display mode, the total number of kilometers ridden is displayed.
Press the button
b"+". No function
Press the button
b"ತ". No function
Press the button
b
for 3 - 5 seconds.
ದ
Press the button
b
briefly.
Next display mode
Display mode SPEED/TR1 (trip master
b1)
400323-01
ದ
Press the button
b
briefly and repeatedly until TR1 appears at the top right of the
display.
TR1 (trip master
b1) runs constantly and counts up to 999.9.
It can be used to measure the distance covered during trips or between two refueling
stops.
TR1 is coupled with A1 (average speed 1) and S1 (stop watch 1).
Info
If 999.9 is exceeded, the values of TR1, A1 and S1 are automaticallt reset to
0.0.
Press the button
b"+". No function
Press the button
b"ತ". No function
Press the button
b
for 3 - 5 seconds.
Displays of TR1, A1 and S1 are reset to 0,0.
Press the button
b
briefly.
Next display mode