Maintenance work on chassis and engine – KTM 450 EXC-R EU User Manual
Page 82
MAINTENANCE WORK ON CHASSIS AND ENGINE
80
200112-10
ದ
Place a suitable container under the engine.
ದ
Remove engine oil plug screen
b
.
ದ
Completely drain the engine oil.
ದ
Thoroughly clean the plug and gear oil screen.
ದ
Clean the sealing area on the engine.
ದ
Check parts for damage and wear. Replace damaged or worn parts.
ದ
Fit plug
b
for the engine oil screen and tighten it.
Specification
Plug, engine oil screen
M17x1,5
20
bNm
(14.8
blbfbft)
Removing the oil filter
b
x
Warning
Danger of scalding
ಘEngine oil and gear oil get very hot when the motocycle is driven.
ದ
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard
ಘProblem materials cause environmental damage.
ದ
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
ದ
Place a suitable container under the engine.
200113-10
ದ
Remove screws
b
. Remove oil filter cover
b
with O-ring.
200114-10
ದ
Pull the oil filter insert
b
out of the oil filter casing.
Circlip pliers reverse (51012011000)
ದ
Completely drain the engine oil.
ದ
Thoroughly clean parts and sealing area.
Mounting oil filter
b
x
200114-11
ದ
Check parts for damage and wear. Replace damaged or worn parts.
ದ
Lay the motorcycle on its side and fill the oil filter housing to about 1/3 full with
engine oil.
ದ
Fill the oil filter
b
with engine oil and place it in the oil filter container.
ದ
Lubricate the O/ring
b
of the oil filter cover.