KTM 450 EXC-R EU - Manual (Page 50)

0 0 2 2
0 0 1 1
0 0 2 2
0 0 1 1
0 0 3 3
0 0 2 2
0 0 1 1
0 0 4 4
0 0 5 5
0 0 6 6
0 0 7 7
0 0 8 8
0 0 9 9
MAINTENANCE WORK ON CHASSIS AND ENGINE
48

Adjusting handlebar position b
x
400223-10
(EXC-R bEU, EXC-RbAUS/UK, EXC-RbUSA, XCR-W)
ದ Remove the four screws b  . Remove the handlebar clamp. Remove the handle-
bar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
ದ Remove the two screws b  . Remove the handlebar support.
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Place the handlebar support in the required position. Fit and tighten the two
screws
b  .
Specification
Screw, handlebar support M10 40 bNm
(29.5 blbfbft)
Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
ದ Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
ದ Position the handlebar clamp. Fit and evenly tighten the four screws b  .
Specification
Screw, handlebar clamp M8 20 bNm
(14.8 blbfbft)
Info
Make sure the gap width is even.
400343-10
(EXC-R bSIXbDAYS)
ದ Remove the four screws b  . Remove the handlebar clamps b  with rubber wash-
ers b  and elastomers b  .
ದ Remove the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering
them.
Do not bend the cables and lines.
ದ Remove the lower shells b  .
ದ Remove the clamp bar b with the rubber cones b .
ದ Remove the two screws b . Remove the handlebar support.
ದ Check parts for damage and wear. Replace damaged or worn parts.