Maintenance work on chassis and engine – KTM 450 EXC-R EU User Manual
Page 56
MAINTENANCE WORK ON CHASSIS AND ENGINE
54
Adjusting chain tension - fitting rear wheel
400225-11
ದ
Loosen nuts
b
.
ದ
Adjust the chain tension by turning the adjusting screws
b
left and right.
Specification
Chain tension
8… 10
bmm (0.31… 0.39bin)
Turn the adjusting screws
b
left and right so that the markings on the left and
right chain adjusters are in the same position relative to the reference marks
b
.
The rear wheel is then correctly aligned.
ದ
Tighten nuts
b
.
Adjusting chain guide
b
x
400252-10
ದ
Remove screws
b
and
b
. Take off the chain guide.
Conditions
Number of teeth:
ืb44bteeth
ದ
Insert nut
b
in hole
b
. Position the chain guide.
ದ
Mount and tighten screws
b
and
b
.
Specification
Remaining screws, chassis
M6
10
bNm
(7.4
blbfbft)
Conditions
Number of teeth:
ุb45bteeth
ದ
Insert nut
b
in hole
b
. Position the chain guide.
ದ
Mount and tighten screws
b
and
b
.
Specification
Remaining screws, chassis
M6
10
bNm
(7.4
blbfbft)
Brake fluid reservoir
Warning
Danger of accidents
ಘBrake system failure.
ದ
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
The brake fluid reservoirs of the front and rear brakes are dimensioned so that they do not need topping up with brake fluid even if the
brake linings are worn.