Maintenance work on chassis and engine – KTM 450 EXC-R EU User Manual
Page 48
MAINTENANCE WORK ON CHASSIS AND ENGINE
46
Greasing the steering head bearing
b
x
(EXC-R
bSIXbDAYS, XCR-WbUSA)
Remove the lower triple clamp. (
P. 43)
Install the lower triple clamp. (
P. 44)
(EXC-R
bEU, EXC-RbAUS/UK, EXC-RbUSA, XCR-WbZA)
Remove the lower triple clamp. (
P. 44)
Install the lower triple clamp. (
P. 45)
Dismounting the front fender
500092-10
ದ
Remove screws
b
. Remove the front fender.
ದ
Make sure that the distance bushings remain in place.
Installing the front fender
500092-10
ದ
Check parts for damage and wear. Replace damaged or worn parts.
ದ
Make sure that the distance bushings are mounted in the fender.
ದ
Position the front fender. Mount and tighten screws
b
.
Specification
Remaining screws, chassis
M6
10
bNm (7.4blbfbft)
Info
Ensure that there is contact between the holding lugs and the start number
plate or headlight mask.
Removing headlight mask with headlight (EXC-R
bEU, EXC-RbAUS/UK, EXC-RbSIXbDAYS, EXC-RbUSA, XCR-WbZA)
500155-10
ದ
Switch off all electrical equipment.
ದ
Remove screw
b
and take off clamp.
ದ
Loosen the rubber band
b
. Push up the headlight mask and swing it forwards.
500156-10
ದ
Pull out the electric plug connector
b
and remove the headlight mask with the
headlight.