KTM 450 EXC-R EU User Manual
Page 49
0
0
B
B
0
0
B
B
0
0
A
A
0
0
A
A
MAINTENANCE WORK ON CHASSIS AND ENGINE
47
Refitting the headlight mask with the headlight (EXC-R
bEU, EXC-RbAUS/UK, EXC-RbSIXbDAYS, EXC-RbUSA,
XCR-W
bZA)
500156-11
ದ
Check parts for damage and wear. Replace damaged or worn parts.
ದ
Connect the electric plug connector
b
.
500155-11
ದ
Position the headlight mask and fix it with the rubber band
b
.
Info
Take care with the contact of the holding lug at the fender.
ದ
Position the brake line and cable harness. Put the clamp on, mount and tighten
screw
b
.
ದ
Check the headlamp setting.
Dismount the start number plate (XCR-W
bUSA)
500101-10
ದ
Remove screw
b
and take off clamp.
ದ
Remove screw
b
with distance bushing. Remove the start number plate.
Fitting the start number plate (XCR-W
bUSA)
500101-11
ದ
Check parts for damage and wear. Replace damaged or worn parts.
ದ
Position the start number plate. Fit and tighten screw
b
with distance bushing.
Specification
Remaining screws, chassis
M6
10
bNm (7.4blbfbft)
Info
Take care with the contact of the holding lug at the fender.
ದ
Position the brake line and cable harness. Put the clamp on, mount and tighten
screw
b
.
Handlebar position
400223-11
On the upper triple clamp, there are 2 holes at a distance of
b
to each other.
Distance
b
between holes
15
bmm (0.59bin)
The holes on the handlebar support are placed at a distance of
b
from the center.
Distance
b
between holes
3.5
bmm (0.138bin)
The handlebar supports can be mounted in 4 different positions.
(EXC-R
bSIXbDAYS)
The handlebar supports can also be mounted at 2 different heights (with and with-
out spacer).
Thick spacer
9
bmm (0.35bin)