Lantronix XPort AR - Manual (Page 120)

12: Advanced Settings
XPort AR User Guide 120
1. Click CLI > Configuration. Figure 12-4 shows the page that displays.
Figure 12-4 CLI Configuration Web Page
2. Enter or modify the fields in Table 12-2 .
Table 12-2 CLI Configuration Fields
Field Description
Login Password Enter the password for Telnet access.
Enable Level Password Enter the password for access to the Command Mode Enable level. There is
no password by default.
Quit connect line Enter a string to terminate a connect line session and resume the CLI. Type
<control> before any key the user must press when holding down the Ctrl
key. An example of such a string is <control>L.
Inactivity Timeout Set an Inactivity Timeout value so the CLI session will disconnect if no data
is received after the designated time period. Default is 15 minutes. Enter a
value of 0 to disable.
Telnet State Select Disabled to disable Telnet access. Telnet is enabled by default.
Telnet Port Enter the Telnet port to use for Telnet access. The default is 23.