Accept mode – Lantronix XPort AR User Manual
Page 43
6: Line and Tunnel Settings
XPort AR User Guide
43
Accept Mode
In Accept Mode, the XPort AR waits for a connection from the network. The configurable local port
is the port the remote device connects to for this connection. There is no remote port or address.
The default local port is 10001 for serial port 1 and 10002 for serial port 2.
Accept Mode supports the following protocols:
SSH (XPort AR acts as the server). When using SSH, the SSH server host keys and at least
one SSH authorized user must be configured.
SSL
TCP
AES encryption over TCP
Telnet (XPort AR supports IAC codes. It drops the IAC codes when Telnetting and does not
forward them to the serial port).
Accept Mode has the following states:
Disabled (never a connection)
Enabled (always listening for a connection)
Active if it receives any character from the serial port
Active if it receives a specific (configurable) character from the serial port (same start
character as Connect Mode’s start character)
Modem control asserted
Modem emulation
To configure Accept Mode, perform the following steps.