Lantronix XPort AR User Manual
Page 46
6: Line and Tunnel Settings
XPort AR User Guide
46
SSH (the XPort AR is the SSH client)
SSL
UDP (available only in Connect Mode because it is a connectionless protocol).
Telnet
Note:
The Local Port in Connect Mode is independent of the port configured in Accept
Mode.
Connect Mode has six modes used to initiate and maintain a connection:
Disable (no connection)
Always (always makes a connection)
Any Character (active if it sees any character from the serial port)
Start Character (active if it sees a specific (configurable) character from the serial port)
Modem Control Asserted (started when the modem control pin is asserted on the serial line)
Modem Emulation (started by an ATD command)
To configure Tunnel 1 Connect Mode, perform the following steps.