Lantronix XPort AR User Manual
Page 49
6: Line and Tunnel Settings
XPort AR User Guide
49
3.
Click Submit.
Reconnect Timer
Enter the reconnect time in milliseconds. The XPort AR attempts to reconnect
after the specified amount of time when a connection fails or when exiting an
established connection. This behavior depends upon the Disconnect Mode.
Notes:
When you configure Tunnel - Connect Mode, you can specify a
number of milliseconds to attempt to reconnect after a dropped
connection has occurred. The default is 1500 milliseconds.
The Reconnect Timer only applies if a Disconnect Mode is configured.
With a Disconnect Mode set, the device server maintains a connection
until the disconnect mode condition is met (at which time the device
server closes the connection). If the tunnel is dropped due to conditions
beyond the device server, the device server attempts to re-establish a
failed connection when the specified reconnect interval reaches its limit.
Any network-side disconnect is considered an error and a reconnect is
attempted without regard to the Connect Mode settings. Simultaneous
Connect Mode connections require some Disconnect Mode
configurations or the connections will never terminate. See
for more information about the parameters.
If Disconnect Mode is disabled and the network connection is dropped,
then the re-establishment of a tunnel connection is governed by the
configured Connect Mode settings.
Flush Serial Data
Select whether to flush the serial line when a connection is made. Choices
are:
Enabled—Flush the serial line when a connection is made.
Disabled—Do not flush the serial line. This is the default.
Block Serial Data
Select On to block (not tunnel) serial data transmitted to the XPort AR.
Block Network Data
Select On to block (not tunnel) network data transmitted to the XPort AR.
Email on Connect
Select whether the XPort AR sends an email when a connection is made.
Select None if you do not want to send an email. Otherwise, select the Email
profile to use.
Email on Disconnect
Select whether the XPort AR sends an email when a connection is closed.
Select None if you do not want to send an email. Otherwise, select the Email
profile to use.
CP Output
Enter a CP Group whose value should change when a connection is
established and when it is dropped.
Connection value—Specifies the value to set the CP Group to when a
connection is established.
Disconnection value—Specifies the value to set the CP Group to
when the connection is closed.
Table 6-7
Tunnel 1 Connect Mode Fields (continued)
Field
Description