Lantronix XPort AR - Manual (Page 63)

8: Configurable Pins Manager
XPort AR User Guide 63
CPM Groups
The CPM Groups page allows for the adding, removing, and managing CP groups. A group, based
on its state, can trigger outside events such as sending email messages. Only an enabled group
can be a trigger.
View CP Group Status
Click the CP group name in the Current Configuration section of the page. Table 8-3 lists and
describes the fields in the groups status section of the page.
Add Custom CP Groups
To add a custom XPort AR CP group, perform the following steps.
Table 8-3 CPM Group Status Fields and Descriptions
Field Description
Name Shows the CP Group name.
State Shows the current state of the CP group. Locked groups are Lantronix
default groups and cannot be deleted. Use the button in this field to enable or
disable the group.
Value Shows the current CP group value.
Bit Displays the 7-bit positions for the CPs in the group.
Level Indicates the voltage level of the CP. A plus sign (+) indicates the CP bit is
asserted (the voltage is high). A minus sign (-) indicates the CP voltage is
low.
I/O Indicates the current status of the pin:
 I—Input
 O—Output
 <blank>—Unassigned
Logic Indicates the output of the CP. An "I" indicates the CP output is inverted. A
blank field indicates that the CP is not inverted.
Binary Shows the assertion value of the corresponding bit. An “x” means that the bit
is unassigned in the group.
CP# Shows the configurable pin number and its bit position in the CP group.