Paxar Monarch TCMPCL2PR - Manual (Page 141)

Error
Code Description
757 Load Supplies. The calibrated supply length differs
by plus or minus .25 inches from the format. Press
R to display the format name.
Press
e to print on the current supply or load
new supply and press
E.
758 Check Supply. Either the on demand sensor is
broken, the supply is not seen, or you have a
continuous unit set to on demand mode. Adjust the
on demand sensor so it is over a white area on the
supply, or set the unit to continuous mode. This
message may also appear on printer models that do
not have the rewind capability.
759 Knife is not moving. Call Technical Support.
760 Knife jam. Call Technical Support.
761 Stacker is full. Empty the stacker before continuing.
762 Low battery. Recharge the battery.
763
Waiting to dispense label. Press the trigger or
f
.
If the error persists, call Technical Support.
764 Verifier failed. Check the verifier by referring to your
verifier’s manual. Call Technical Support.
765 The printhead has less than 4 bad dots. The printer
can shift bar code fields to avoid bad dots. Press
E to continue printing.
768 Printhead has more than 10 bad dots or is not
connected. Make sure the printhead is connected.
You may need a new printhead. Call Technical
Support.
Chapter 9. Errors
9-19