Paxar Monarch TCMPCL2PR - Manual (Page 142)

Error
Code Description
770 The print motor is not ready. Call Technical Support.
771 The format specified by the application was not
found. Reload your application and format, and try
again. If the problem continues, call Technical
Support.
790 Wait until the printer is idle (no batch waiting to print
or not receiving data) before you send any packets.
This error may occur when you try to print a test
label if the printer is busy.
791 The printer has an error pending. Turn off the
printer. Wait 15 seconds and turn it back on.
Resend the packets. If the problem continues, call
Technical Support.
792 The printer is not initialized. Call Technical Support.
793 The printer job queue is full. Turn off the printer.
Wait 15 seconds and turn it back on. Resend the
packets. If the problem continues, call Technical
Support.
Errors numbered 900-911 occur when you turn on the printer.
They may indicate a circuit board failure. Errors numbered
930-940 are errors that may occur during the loading of flash
memory. Errors numbered 950-999 indicate a circuit board
failure. Call Technical Support if you receive any of these
messages.
900 RAM test failure.
901 ROM/EPROM checksum failure.
902 Software timer failure.
903 Software interrupt failure.
MPCLII Packet Reference Manual
9-20