Panasonic WJ-SX 150A - Manual (Page 141)

145
This section will describe what you should take notice when using a PS·Data system controller.
The same descriptions as the system controller’s operating instructions are not mentioned here. Refer to them.
Notes:
• Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the
time-lapse VCR, and configure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and time-lapse
VCR's SETUP MENU. [Refer to p. 32 Installing the Multiplexer Board, p. 46 Connection with the Time-lapse VCR
(Panasonic Models), p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79 WJ-SX150A ADMINISTRATOR CONSOLE.]
• The time-lapse VCR's SETUP MENU cannot be displayed from a system controller.
■ Controlling the Time-lapse VCR with a PS·Data System Controller
1. Enter the recorder mode. (Refer to p. 141.)
2. Press the SHIFT button to activate the FUNCTION buttons.
3. Enter the desired function code, and then press the FUNCTION button. (Refer to the diagram.)
4. To select a camera channel, press the numeric button(s), then CAM button. The system will exit from the recorder mode,
and the selected camera image will be displayed on the monitor.
Notes:
• Only one operator can enter the recorder mode.
• The images from the recorder, which are displayed on the monitor, is conformed to the recorder setting.
● Stopping REC ONLY Alarm Recording
The operations are the same as WJ-HD500 Series. Refer to p. 142.
TIME-LAPSE VCR CONTROL [PANASONIC MODELS] (PS·DATA) MUX
Function Code Note
Forward field advance 1 Available only during pause
Backward field advance
Pause
Playback
Recording
Stop recording/Playback
Fast-forward/Search forward
Rewind/Search backward
2
4
5
6
8
11
12
Available only during pause
Fast-forward during stop/Search forward during playback
Rewind during stop/Search backward during playback