Panasonic WJ-SX 150A - Manual (Page 179)

7
■ Patrol Learn and Play
A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera. (Refer to p. 3
Monitor Selection and p. 3 Camera Selection.)
2. To save the patrol sequence, follow the procedure
below.
q Press the MENU button repeatedly until "Patrol
Learn" will appear on the LCD.
w Press the F1 button.
e Operate the camera manually.
r Press the F2 button.
The operation data will be saved.
3. To reproduce the operation data, follow the procedure
below.
q Press the MENU button repeatedly until "Auto
Mode" appears on the LCD.
w Press the F4 button.
e To stop the reproduction, move the 3D joystick.
4. To exit the mode, press the MON (ESC) button.
Patrol Learn 007
Start Stop
Auto Mode 009
Seq Sort Pan Patrol
■ Auto Pan Setup and Activation
You will set up and activate the auto pan function. The cam-
era can pan between the start and end points you will set.
1. Select the desired monitor and camera. (Refer to p. 3
Monitor Selection and p. 3 Camera Selection.)
2. Press the MENU button repeatedly until "Auto Pan
Setup" appears on the LCD.
3. To set the start and end point of auto pan, perform the
following.
q To move the camera to a point you wish to start
auto pan, move the 3D joystick and press the lens
control buttons (IRIS OPEN and CLOSE, FOCUS
FAR and NEAR).
w Press the F3 button.
The start point of auto pan will be set.
e To move the camera to a point you wish to end auto
pan, move the 3D joystick.
r Press the F4 button.
The end point of auto pan will be set.
Auto Pan Setup 008
Play Rvrs Start End