Panasonic WJ-SX 150A - Manual (Page 142)

146
TIME-LAPSE VCR CONTROL [NON-PANASONIC MODELS] (PS·DATA) MUX
A time-lapse VCR is operable with the system controller,
while connecting to the matrix switcher.
Notes:
• The same descriptions as the system controller’s
operating instructions are not mentioned here. Refer
to them.
• Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the digital disk recorder, and
configure the system through WJ-SX150A
Administrator Console, OSD SETUP MENU, and
time-lapse VCR's SETUP MENU. [Refer to p. 32
Installing the Multiplexer Board, p. 47 Connection
with the Time-lapse VCR (Non-Panasonic Models),
p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79
WJ-SX150A ADMINISTRATOR CONSOLE.]
• You cannot control non-Panasonic time-lapse VCRs
from PS·Data system controllers.
The following is the procedure of a non-Panasonic model
time-lapse VCR.
■ Controlling the Time-lapse VCR
with a PS·Data System
Controller
● Manual Recording
Refer to the time-lapse VCR’s operating instructions for how
to operate.
● Normal Playback
1. Enter the recorder mode. (Refer to p. 141.)
2. Do the playback procedure using the buttons on the
front panel of time-lapse VCR. (Refer to the time-lapse
VCR’s operating instructions for how to operate.)
3. Press the VCR/CAM button. The playback image will
appear on the monitor.
4. To display the spot picture, press the numeric buttons
corresponding to the desired camera number, then
press the CAM [SET] button. Then, the active monitor
number with “-H**” (** is logical the camera number)”
will appear on the LED display. (Refer to p. 132 Normal
Playback for the illustration.)
● Other Operations
Refer to the time-lapse VCR’s operating instructions for how
to operate.