Panasonic WJ-SX 150A - Manual (Page 87)

90
REC
This stands for a recorder activated with an alarm signal.
(Refer to the diagram in p. 68.)
Alarm Port
Select the unit whose alarm port is activated with an alarm
signal. Master or Slave 1/2/3/4 is selectable.
Num
Select the alarm port number. 1 to 16 is selectable. To
deactivate the alarm event, select “- -”.
Notes:
• If having selected a tour sequence for a monitor, anoth-
er tour number or spot camera will not be available
when selecting the monitor for another alarm event.
That will result in an error.
• Each Alarm Port and Num can be assigned to only one
ALM. When you enter the same Alarm Port and Num
more than one time, a message will appear. If you click
on “Yes”, the newer will be activated and the older will
be changed to “- -“. If you click on “No”, the changed
parameters will return to the former state.
(Save Exit) button
Saves the configuration and closes the Alarm Event win-
dow.
(Cancel Exit) button
Cancels the configuration and closes the Alarm Event win-
dow.
■ Alarm Port
This window configures the parameters of alarm inputs.
● How to Display
To display this window, click on the (Alarm Port) but-
ton in the main window (p. 80).
● Parameters
Select the desired alarm input parameter to assign in each
alarm port's drop-down menu.
Normally Open: Normally Open contact.
Normally Close: Normally Close contact
Time Adjust: Time adjustment signal
(Save Exit) button
Saves the configuration and closes the Alarm Input window.
(Cancel Exit) button
Cancels the configuration and closes the Alarm Input win-
dow.
■ Operator Registration
This window configures the parameters of each operator:
the ID, password, level, priority and camera access.
Note: Before configuring this window, check on the
restrict level of each operation in the Level Table
window.
● How to Display
To display this window, click on the (Operator
Registration) button in the main window (p. 80).