Panasonic WJ-SX 150A - Manual (Page 57)

60
■ Error List
The following error messages are displayed through SX150
Program Writer.
● File Error
This error message is displayed during the following occa-
sions.
• You have selected a wrong file (whose file extension is
not “. mot”) in Step 13 of p. 59.
• The “.mot” file is broken.
To solve this problem, select the correct file. (Refer to p.
59.)
● Not Ready
This error message is displayed when the matrix switcher’s
mode is not “SX150 SOFTWARE UPLOAD”.
To solve this problem, do the following.
1. Power off the matrix switcher.
2. Set the mode selector of the matrix switcher to “SX150
SOFTWARE UPLOAD”. (Refer to p. 24.)
3. Power on the matrix switcher again.
● Timeout Error
This error message is displayed when a specified time has
passed since you started installing SX150A Program
Writer/updating the firmware. The following are the timeout
error statuses.
Status 0: 30 seconds has passed since the PC
became idle.
Status 1: 30 seconds has passed since the SD-RAM
started to be cleared.
Status 3: 20 minutes has passed since the file transfer
was started.
Status 4: 30 seconds has passed since the file transfer
was completed.
Status 5: 30 seconds has passed since the file loading
became OK.
Status 6: 5 seconds has passed since the file erasing
is started.
Status 7: 5 seconds has passed since the file writing is
started.