Panasonic WJ-SX 150A - Manual (Page 7)

7
PRECAUTIONS
DOCUMENT CONVENTION
• Refer all work related to the installation of this
product to qualified service personnel or system
installers.
• Do not block the ventilation opening or slots on the
cover.
To prevent the appliance from overheating, place it at
least 5 cm (2 inches) away from the wall.
• Do not drop metallic parts through slots.
This could permanently damage the appliance. Turn
the power off immediately and contact qualified service
personnel for service.
• Do not attempt to disassemble the appliance.
To prevent electric shock, do not remove screws or
covers.
There are no user-serviceable parts inside. Contact
qualified service personnel for maintenance.
• Handle the appliance with care.
Do not strike or shake, as this may damage the appli-
ance.
• Do not expose the appliance to water or moisture.
Do not try to operate it in wet areas.
Take immediate action if the appliance gets wet. Turn
the power off and refer servicing to qualified service
personnel. Moisture can damage the appliance and
also cause electric shocks.
• Do not use strong or abrasive detergents when
cleaning the appliance body.
Use a dry cloth to clean the appliance when it is dirty.
When the dirt is hard to remove, use a mild detergent
and wipe gently.
• Do not operate the appliance beyond its specified
temperature, humidity, or power source ratings.
Use the appliance at temperatures within –10 °C -
+50 °C (14 °F - 122 °F) and humidity below 90 %.
The input power source for this appliance is 120 V AC,
60 Hz.
• We recommend that you note down your settings
and save them. Power or battery failure may erase
the settings you enter.
This operating instructions use the following convention when describing the use and operation of this unit.
Unit: Panasonic Matrix Switcher WJ-SX150A
Multiplexer board : Panasonic Multiplexer Board WJ-SXB151
System controller: Panasonic System Controller WV-CU360C or WV-CU360CJ
Recorder: Panasonic Digital Disk Recorder or a time-lapse VCR* (*Available only when the Multiplexer board is installed)
Receiver: Panasonic Indoor Receiver WV-RC100 or Outdoor Receiver WV-RC150
System: Surveillance control system
Master recorder: Recorder connected to the Master unit in a master-slave connection
Slave n* recorder: Recorder connected to Slave n unit in a master-slave connection
* n is a unit number.
Notes:
• Text with this appearance is a special instruction, rule, or side comment related to the topic.
• In these operating instructions, WV-CU360C is used for the illustrations and descriptions of the system controller.
Symbol Used in The Operating Instructions
These operating instructions use the icon shown below to describe the functions available when the Multiplexer board is
installed in the unit.
: Functions available with the Multiplexer board MUX
MUX