Panasonic WJ-SX 150A - Manual (Page 50)

52
Pattern 4: Master, Slave 1 to 4 are connected in the system.
Note: Before connections, make sure all the units have the same firmware version. You can see the firmware version of each
unit in SETUP MENU. (Refer to pp. 72 and 73 710 MASTER-SLAVE.) In case there is a version difference, update the
firmware of each unit to the newest using a CD-ROM. (Refer to pp.58 to 60 FIRMWARE UPDATE.)
● Preparation
Prepare the following items besides standard accessories.
• Personal computer x 1 (Refer to p. 79 Platform for details on system requirements.)
• 9-pin D-sub crossing cable x 1 (Used for connection between the PC and the Master unit)
• Phillips screwdriver x 1 (Used for opening the front panel and setting unit numbers)
• Coaxial cable* (Used for connection of the Master and Slave units)
• Cable Kit WV-CA48/10K* (Used for connection of more than one Slave unit)
* Necessary number will differ depending on the connection pattern.
● Unit Number Selection
Set the unit number selector of each unit to determine Master and slave n*. (Refer to the illustration and diagram in p. 24.)
*n is a unit number.
REC
Digital Disk Recorder
WJ-HD A
FS 16 16
Camera 1 to 16
Slave 1
HDR PSD D3 D2 D1 CAM
REC
Digital Disk Recorder
WJ-HD A
FS 16 16
Camera 17 to 32
Slave 2
HDR PSD D3 D2 D1 CAM
Master
REC
Digital Disk Recorder
WJ-HD A
FS 16 16
Camera 33 to 48
Slave 3
HDR PSD D3 D2 D1 CAM
REC
Digital Disk Recorder
WJ-HD A
FS 16 16
Camera 49 to 64
Slave 4
HDR PSD D3 D2 D1 CAM
MONITOR OUT 1 to 4
HDR D3 D2 D1 CAM PSD
Terminal - mode PS • Data
MON1 → CAM1
MON2 → CAM2
MON3 → CAM3
MON4 → CAM4
MON1 → CAM9
MON2 → CAM10
MON3 → CAM11
MON4 → CAM12
MON1 → CAM13
MON2 → CAM14
MON3 → CAM15
MON4 → CAM16
MON1 → CAM5
MON2 → CAM6
MON3 → CAM7
MON4 → CAM8