Panasonic WJ-SX 150A - Manual (Page 209)

37
(2) ADDENDUM FOR MATRIX SWITCHER WJ-SX150 SERIES:
TO USE DIGITAL DISK RECORDER
WJ-HD300 SERIES/WJ-HD220 SERIES
■ Connection with Digital Disk Recorder WJ-HD300 Series
Notes:
• Refer to service personnel for details on the connection with a recorder to operate via LAN or the Internet.
• Check that the firmware of recorder is Ver. 1.30 or later.
• Only one recorder can be connected to the DATA HDR connector of this unit. (Multiple unit connections, such as cascade
connection, are not available.)
● Basic Connection
The following is the description of the connection between a recorder and this unit to confirm the images from the recorder.
1. Set the unit address of the recorder to 1.
2. Set the [Camera control] setting to “PSD” for all cameras in SETUP MENU of the recorder.
3. Connect the unit’s CAM OUT 1 to 16 connectors to the recorder’s VIDEO IN 1 to 16 connectors with a coaxial cable.
4. Connect the unit’s EXT IN connector to the recorder’s MULTISCREEN OUT connector with a coaxial cable.
5. Connect the unit’s DATA HDR connector to the recorder’s DATA port with a modular cable.
SIGNAL GND
POWER
AC IN
CAMERA 1
1
2
2
3
3
2
DATA 3 DATA 2
SERIAL ALARM
TERM OFF ON 4
2
1
4
3
CAMERA SW IN RS485(CAMERA)
LINE SELECT
MONITOR OUT
EXT IN
(PLAY IN)
EXT OUT (REC OUT)
OUT
IN
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
13
13
14
14
15
15
16
16
RS485(CAMERA)
DATA 4 DATA HDR
PS•DATA
DATA 1
1 2
IN
OUT
CASCADE OUT
16
16
3
15
15
14
14
13
2
1
13
12
12
11
11
10
10
9
9
8
8
7
7
6
6
5
5
4
4
3
3
2
2
1
1
VIDEO
AUDIO IN AUDIO OUT MONITOR OUT CASCADE IN MONITOR (VGA) ALARM/CONTOROL
SERIAL ALARM
POWER
COPY 1 MODE
EXT STORAGE 10/100BASE-T RS485(CAMERA) DATA
AC IN
SIGNAL GND 1
4 2
System controller
(Terminal Mode)
EXT IN MONITOR OUT
Matrix Switcher
Recorder**
DATA 4*
(PS·Data) DATA HDR
MONITOR OUT x
DATA
* Connect these ports if you control cameras from the front panel of recorder.
** Set the recorder’s unit address to 1.
Monitor
Notes:
• Make sure the recorder’s unit address is set to 1 through SETUP MENU or WJ-SX150A administrator Console. (Refer to this
unit’s operating instructions.) If another number is selected, you cannot control the recorder.
• To control cameras at the front panel of recorder, connect the DATA 4 connector and the DATA port of recorder with a
modular cable. (PS·Data system controller is not connectable to the DATA 4 connector.)
• From system controllers connected to the unit (WJ-SX150A), you cannot control the monitor connected to the MONITOR
OUT 1 connector of recorder.
SYSTEM CONNECTIONS AND SETUPS (WJ-HD300 SERIES/WJ-HD220 SERIES)