Panasonic CS-A9CKPG User Manual
Page 46
1.
The equipment must be earthed. It may cause electrical shock if grounding is not perfect.
2.
Do not install the unit at place where leakage of flammable gas may occur. In case gas leaks and accumulates at
surrounding of theunit, it may causefire.
3.
Carry out drainage piping as mentioned in installation instructions. If drainage is not perfect, water may enter the room and damage the
furniture.
1.
Selection of the installation location.
Select a installation location which is rigid and strong enough to support or hold the unit, and select a location for easy maintenance.
2.
Power supply connection to the room air conditioner.
Connect the power supply cord of the room air conditioner to the mains.
Power supply point should be in an easily accessible place for power disconnection in case of emergency.
Power supply connection to a circuit breaker for the permanent connection. Use an approved 15A (CU-A9CKP6G) and 20A (CU-
A12CKP6G) fuse or circuit breaker for the permanent connection.
It must bea doublepoleswitch with a minimum 3 mm (0.12 inch) contact gap.
3.
Do not release refrigerant.
Do not release refrigerant during piping work for installation, reinstallation and during repairing a refrigeration parts. Take care of the
liquid refrigerant, it may cause frostbite.
4.
Installation work.
It may need two people to carry out the installation work.
5.
Do not install this appliance in a laundry room or other location where water may drip from the ceiling, etc.
6.
It is not possible to carry out installation when the outdoor unit temperature reach -12°C (10.4°F).
46
CS-A9CKPG CU-A9CKP6G / CS-A12CKPG CU-A12CKP6G