Panasonic CS-A9CKPG - Manual (Page 50)

1. Remove the control board metal cover.
2. Unscrew theconduit cover & fix theconduit connector to
conduit cover with lock nut, then secure it against chassis.
3. Connecting between indoor unit and outdoor unit should be
UL listed or CSA approved 6 × AWG16 wire.
•
Ensurethecolor of wire s of outdoor unit and the
terminal Nos. are the same as the indoor’s respectively.
•
Earth lead wire should be longer than the other lead
wires as shown in the figure for the electrical safety in
casethecord slips out from theanchorage.
•
Securethewireonto thecontrol board with theholder
(clamper).
4. After completed wiring connection, fix back the metal cover
to theoriginal location.
INSTALLATION OF AIR PURIFYING FILTERS
1. Open the front panel.
2. Remove the air filters.
3. Put air purifying filters (left) and solar refreshing deodorizing
filter (right) into place as shown in illustration below.
11.2.5. INDOOR UNIT ELECTRICAL WIRING
50
CS-A9CKPG CU-A9CKP6G / CS-A12CKPG CU-A12CKP6G