Nortel Networks M7410 - Manual (Page 108)

P0908510 Issue 02 Enterprise Edge Feature Programming Telephone Guide
General System features
The following features are available for the entire Enterprise Edge system.
Pulse or tone dialing
If your external lines use pulse dialing, you can switch temporarily to tone dialing
to communicate with devices such as answering machines, to access the features
that PBX systems may offer, or to use another Enterprise Edge system remotely.
Press
£
while on an active line. Once you hang up, your telephone returns to pulse
dialing.
Disconnect supervision
When Disconnect Supervision is assigned to a line, the Enterprise Edge system
monitors it to detect if an external caller hangs up. This allows the system to release
the line for other uses. Your installer assigns disconnect supervision.
Hunt Groups
Your Enterprise Edge system now allows you to establish Hunt Groups in your
system. Hunt Groups are a group of Enterprise Edge sets that can be called by a
single directory number. The Hunt Groups feature ensures calls are easily routed to
the appropriate people. For more information on Hunt Groups see
Hunt Groups on
page 83.
Internal numbers
Each telephone in the Enterprise Edge system has its own internal number. The
length of internal numbers in your system can be from two to seven digits on a non-
expanded system, and three to seven digits on an expanded system. All numbers in
your system are the same length. Your installer sets the length of internal numbers
(called the DN length). The default DN length is three.
To find out your internal number, use the Button Inquiry feature (
ƒ•‚
)
on an intercom button. On the M7100 telephone, Button Inquiry shows your
internal number followed by the function assigned to your single-memory button.
Line assignment
Any of the lines in your system can be assigned to any of your telephones. Your
installer assigns lines to telephones in Configuration programming. Lines can be
assigned to appear only, appear and ring, or to ring only.
15