Nortel Networks M7410 - Manual (Page 39)

38 Time savers for making calls
Enterprise Edge Feature Programming Telephone Guide P0908510 Issue 02
Using intercom as the line for Autodial
If you press
∆
as the line for an external autodial number, you must include
a valid line pool access code or a destination code. If line pool access codes or
destination codes are changed, remember to reprogram autodial numbers.
Displays
Continue to enter digits until the number is complete. Press
√ or BKSP to erase an incorrect digit. Press
˙ or OK when you are finished.
The memory allotted to autodial numbers in your Enterprise
Edge system is full.
While programming external Autodial, you erased the button by
pressing
˙ or OK before entering any digits.
Enter the number you want to program (choosing the line first if
necessary) exactly as if you were making a call.
Enter the internal telephone number you want to program.
You are programming an internal autodial button and have
entered a number that is not an internal number on your system.
Enter a valid internal number. If the number you are entering is
a destination code, use external autodial.
Press the memory button you want to program.
Enter the number you want to program onto the button, then
press
˙ .
Enter the number you want to program onto the button, then
press
˙ or OK . You may include a line or line pool
selection in an autodial sequence by selecting the line before
entering any digits.
The number is stored on the button.
For other displays, see Common feature displays on page 125.
987___
QUIT
BKSP OK
Autodial full
Button erased
Enter digits
QUIT
OK
Intercom #: ___
QUIT
Invalid number
Press a button
QUIT
Program and HOLD
Program and OK
QUIT
OK
Programmed