Nortel Networks M7410 - Manual (Page 113)

112 Hospitality Services
Enterprise Edge Feature Programming Telephone Guide P0908510 Issue 02
If the Enterprise Edge system experiences a power failure, the failure can result in
missed Alarm times. When the Enterprise Edge system is running and the system’s
time resets, the missed Alarm times alert in respective room or common sets. At all
times, the Enterprise Edge system allows up to a maximum of 25 sets that can alert
at the same time.
Programming the Alarm time feature
To program the Alarm time feature on an Enterprise Edge telephone:
1. Press ƒ°‡fi. The display shows Alrm: 07:00am OFF.
If the alarm time is correct press ON/OFF. The display shows Alrm:07:00am
ON. Press DONE to exit.
or
To enter a new alarm time press CHG. The display shows Enter time:.
2. Enter a new 4 digit alarm time.
If the 24 hour clock format is used (hour: 00 to 23 and minutes: 00 to 59), no
confirmation is required. The display shows
Alarm ON hh:mm .
If the 12 hour format is used, the display shows hh:mm AM or PM?. Press the AM
or PM display key. The display shows Alarm ON hh:mm .
To program the Alarm time feature on an analog telephone:
1. Press ˚•°‡fi. A tone sounds.
2. Enter a 4 digit alarm time.
If the 24 hour clock format is used (hour: 00 to 23 and minutes: 00 to 59), a
tone sounds.
If the 12 hour format is used, press • to select am or £ to select pm. A tone
sounds.
At the selected times, sets in the room ring to wake-up or remind the occupant of
the next event or meeting.
Changing or canceling an earlier selected Alarm time
To set a new time for an Alarm time, re-enter a new Alarm time. The new time
overwrites any earlier set time. Canceling the Alarm time for any set cancels the
Alarm time for all the sets in the same room.
Canceling the alarm
• To cancel the Alarm time on an Enterprise Edge telephone, press
ƒ£°‡fi.
The display shows Alarm OFF.
• To cancel the Alarm time on an analog telephone press
˚£°‡fi.