M7100 telephone, Memory buttons, Oneline display – Nortel Networks M7410 User Manual
Page 110: M7100 telephone 109, Memory buttons 109 one-line display 109
General System features 109
P0908510 Issue 02
Enterprise Edge Feature Programming Telephone Guide
Overflow routing for incoming calls is used with the Routing Service programmed
by your installer. A Service must be active for overflow routing to be in effect.
Overflow routing is not available in normal service.
M7100 telephone
Because the M7100 telephone does not have line buttons, it sometimes works
slightly differently from other Enterprise Edge telephones. Where other telephones
can require that you select a line button to answer a call, on the M7100 telephone
you simply pick up the receiver. Where other telephones require you to select a line
button to take a call off hold, you press
˙
on the M7100 telephone.
On M7100 telephones, you can answer a second call by pressing
˙
. Your
active call is put on hold and you are connected to the waiting call. You can have
no more than two calls at a time.
The M7100 telephone cannot have a
©
button. When applicable, special
instructions for the M7100 telephone are included with each feature description.
Memory buttons
Memory buttons are the buttons with indicators on the M7310, M7208, and M7324
telephones, and the dual buttons without indicators on the M7310 telephone. There
is a single memory button, without an indicator, on the M7100 telephone. Memory
buttons can be used as answer, autodial, line, and programmed feature buttons.
Line, intercom and answer buttons must have indicators.
One-line display
The M7100 telephone has a one-line display. Other Enterprise Edge telephones
have a second line on the display which shows the functions of the three buttons
directly below it.
Tips
When you make a call and the programmed route is busy, you hear the
expensive route warning tone and see a display indicating that an expensive
route is being used. To avoid using the normal, expensive route, release your
call.
Because overflow routing directs calls using different line pools, a call may
be affected by different line filters when it is handled by overflow routing.