Hospitality services admin alarm feature, Hospitality services admin alarm feature 113 – Nortel Networks M7410 User Manual
Page 114
Hospitality Services 113
P0908510 Issue 02
Enterprise Edge Feature Programming Telephone Guide
Turning off the Alarm
When a set rings at the selected time, the occupant can release the Alarm ring as
follows:
•
On an Enterprise Edge telephone, press any button except the ˙
button.
•
On an analog telephone lift and replace the handset back into position.
Note: If the user presses the ˙ button when the set rings, it temporarily
deactivates the Alarm. After a number of minutes, the set will alert again.
If the user is on a call when the alarm sounds they can press any key except
Release to cancel the alarm and maintain their active call.
Hospitality Services admin alarm feature
Only a Hospitality Services (HS) admin set can use the Hospitality Services admin
alarm feature. The Hospitality Services admin alarm feature is room oriented only,
it does not control the alarms on common sets.
The Hospitality Services admin feature can:
•
query the current or last alarm time set for a room
•
overwrite previous Alarm time programming for a room on the system
- assign an Alarm time for any room on the system
- change an Alarm time for any room on the system
- cancel an Alarm pending for any room on the system
To program the Alarm time for a room with the Hospitality Services admin alarm
feature:
1. Press ƒ°‡‡ on a two-line display Enterprise Edge telephone
(M7310 or M7324).
2. If configured, the display shows Password:. Enter the Desk admin password.
3. The display shows Al of rm#:. Enter the room number.
4. Press VIEW. The display shows Alrm: 07:00am OFF:. If the alarm time is
correct press the ON/OFF display key to activate the alarm.
5. Enter a four digit alarm time.
If the 24 hour format is used (hour: 00 to 23 and minutes: 00 to 59), no
confirmation is required. The display shows Alarm hh:mm ON.
If the 12 hour format is used, the display shows the four digit time plus AM or
PM?. Press the AM or PM display key. The display shows Alarm hh:mm am or pm
ON.
6. Press the Release button to exit programming.