Nortel Networks M7410 - Manual (Page 35)

34 Making calls
Enterprise Edge Feature Programming Telephone Guide P0908510 Issue 02
Changing how you dial your calls
ƒ•°¤
1. Press
ƒ•°¤
.
2. Press
£
or NEXT until the dialing mode you want appears.
3. Press
˙
or OK to select the displayed dialing mode.
The dialing modes feature code cannot be programmed onto a memory button.
Using Standard dial
Standard dial allows you to make a call by selecting a line and dialing the number.
If you have a prime line, it is selected automatically when you lift the receiver or
press
©
.
You cannot use Standard dial on a M7100 telephone unless you pick up the receiver
first. If you have a M7100 telephone, use the Automatic dial or Pre-dial feature for
on-hook dialing.
Using Automatic dial
Automatic dial allows you to dial a number without selecting a line. Your prime line
is selected as soon as you start dialing a number.
Automatic dial does not work if your telephone has no prime line or if your prime
line is in use.
Telephones connected to an Enterprise Edge Analog Terminal Adaptor (ATA2) or
an Enterprise Edge Analog Station Module (ASM) cannot use Automatic dial.
Using Pre-dial
Pre-dial allows you to enter a telephone number, check it, then change it before
actually making the call. The call is not dialed until you select a line or line pool, or
pick up the receiver. You can pre-dial both external and internal numbers. You
must, however, select the correct type of line (external or internal) for the type of
number you have entered.
Tip
If your telephone starts ringing while you are pre-dialing a number, you can
stop the ringing by turning on Do Not Disturb (ƒ°fi). This does
not affect numbers you are entering.
You cannot pre-dial a telephone number if all the lines on your telephone are
busy.